Honda SH300I 2006, Manual

Page: 392 / 511

HYDRAULIC BRAKE
17-34
ASSEMBLY
Coat a new dust seal with silicone grease, new pis-
ton seal with clean brake fluid and install them into
the seal grooves in the caliper cylinder.
Coat the caliper piston with clean brake fluid and
install it into the caliper cylinder with the opening
side toward the pad.
Check the caliper/bracket pin boots and replace
them if they are hard, deteriorated or damaged.
Apply 0.4 g minimum of silicone grease to the cali-
per/bracket pin boots, and install them into the cali-
per body and bracket.
Install the caliper pin to the pin boot as shown.
Install the caliper bracket to the caliper body.
CALIPER PISTON
CALIPER BODY
CALIPER PIN
PIN BOOT
RETAINERS
PIN BOOT
CALIPER BRACKET
BLEED VALVE
DUST SEAL PISTON SEAL
CALIPER BOLT
CALIPER PIN BOLT
5.4 N·m (0.6 kgf·m, 4.0 lbf·ft)
22 N·m (2.2 kgf·m, 16 lbf·ft)
22 N·m (2.2 kgf·m, 16 lbf·ft)
PISTON
PISTON SEAL
DUST SEAL
BRACKET
CALIPER BODY
CALIPER PIN
PIN BOOTS
RETAINERS