Honda SH300I 2006, Manual

Page: 496 / 511

IMMOBILIZER SYSTEM (HISS)
23-12
IMMOBILIZER INDICATOR
INSPECTION
Check the combination meter initial function (page
22-8).
If the all needles show initial functions but immobi-
lizer indicator does not stay on, check the following:
Remove the rear fender A (page 3-7).
Disconnect the ECM 33P connector.
Turn the ignition switch ON and measure the volt-
age between the ECM connector of the wire harness
side and ground.
If there is battery voltage, immobilizer indicator line
is normal.
If there is no voltage, check the following:
Remove the front handlebar cover (page 3-14).
Disconnect the combination meter 16P connector.
Check for continuity between the ECM connector
and combination meter connector of the wire har-
ness side.
If there is no continuity, open circuit in White/Red
wire between the combination meter and ECM.
There should be continuity, check the following.
Check for continuity between the ECM connector
and ground with combination meter connector dis-
connected.
If there is continuity, there is short circuit in White/
Red wire.
If there is no continuity, replace the meter circuit of
the combination meter with a new one and recheck.
TOOL:
Test probe
07ZAJ-RDJA110
CONNECTION: White/Red (+) – Ground (–)
ECM 33P CONNECTOR
33P CONNECTOR
(Wire side of
female terminal)
W/R
TOOL:
Test probe
07ZAJ-RDJA110
CONNECTION: White/Red – White/Red
33P CONNECTOR
(Wire side of
female terminal)
16P CONNECTOR
(Wire side of
female terminal)
W/R
TOOL:
Test probe
07ZAJ-RDJA110
CONNECTION: White/Red – Ground
33P CONNECTOR
(Wire side of
female terminal)
W/R