Honda SH300I 2006, Manual

Page: 22 / 511

GENERAL INFORMATION
1-18
FRAME
MATERIAL LOCATION REMARKS
Multi-purpose grease Seat catch sliding area Apply 1.5 g minimum
Sidestand pivot sliding area
Centerstand pivot inside
Apply 3.0 g minimum
Centerstand shaft sliding surface
Throttle grip pipe flange cable groove
Apply 0.1 – 0.2 g
Engine hanger bracket B needle bearing
Engine hanger bracket B inner collar outer surface
Engine hanger bracket B dust seal lips
Front wheel dust seal lips
Front wheel bearing whole surface
Swingarm dust seal lips
Passenger footpeg contact area
Final shaft outer surface (swingarm bearing fitting
area)
Final shaft groove
Apply 0.03 – 0.04 g
Urea based multi-purpose
grease with extreme pres-
sure agent (example:
EXCELITE EP2 manufac-
tured by KYODO YUSHI,
Japan), Shell Stamina EP2
or equivalent Steering head bearings Apply 3 – 5 g each
Steering head dust seal lips
Engine oil Fuel pump rubber seal inner surface Apply 1.0 g maximum
Honda bond A, Honda hand
grip cement, Cemedine #540
or equivalent Handlebar grip rubber inside
Brake caliper bracket pad retainer
Silicone grease Throttle cable inside Apply 0.2 g minimum
Throttle cable boot inside Apply 0.1 cc
Brake master cylinder piston boot inner surface
Brake lever contacting area with piston
Apply 0.1 g
Brake lever pivot sliding area Apply 0.1 g
Pad pin stopper ring outer surface
Brake caliper dust seal
Brake caliper pin sliding area and boot
Apply 0.4 g minimum
Brake caliper bracket pin sliding area and boot Apply 0.4 g minimum
DOT 4 brake fluid Master cylinder piston outer surface and cup
Caliper piston whole surface
Caliper piston seal whole surface
Brake pipe joint nut threads
Fork fluid Fork oil seal lips
Fork dust seal lips
Spring seat O-ring
Locking agent Fork socket bolt threads
Sensor protector socket bolt threads