Honda SH300I 2006, Manual

Page: 459 / 511

LIGHTS/METERS/SWITCHES
22-3
SERVICE INFORMATION
GENERAL
Note the following when replacing the halogen headlight bulb.
–
Wear clean gloves while replacing the headlight bulb. Do not put fingerprints on the headlight bulb, as they may create
hot spots on the bulb and cause it to fail.
– If you touch the bulb with your bare hands, clean it with a cloth moistened with alcohol to prevent its early failure.
• A halogen headlight bulb becomes very hot while the headlight is on, and remains hot for a while after it is turned off.
Be sure to let it cool down before servicing.
• Be sure to install the dust cover after replacing the bulb.
• Use an electric heating element to heat the water/coolant mixture for the ECT sensor inspection. Keep all flammable
materials away from the electric heating element. Wear protective clothing, insulated gloves and eye protection.
• Check the battery condition before performing any inspection that requires proper battery voltage.
• A continuity test can be made with the switches installed on the scooter.
• The following color codes used are indicated through out this section.
SPECIFICATIONS
TORQUE VALUES
Bu: Blue G: Green Lg: Light Green W: White
Bl: Black Gr: Gray O: Orange Y: Yellow
Br: Brown Lb: Light Blue R: Red
ITEM SPECIFICATIONS
Bulb Headlight (high/low beam) 12 V - 60/55 W
Brake/taillight 12 V - 21/5 W
License light 12 V - 5 W
Turn signal light 12 V - 21 W x 4
Position light 12 V - 5 W x 2
Instrument light LED
High beam indicator 12 V - 1.12 W
Turn signal indicator 12 V - 1.4 W x 2
PGM-FI malfunction indicator LED
Engine oil pressure indicator 12 V - 1.4 W
Engine oil change indicator LED
Fuse Main fuse 30 A
Sub-fuse STD type 15 A x 1, 10 A x 5
ABS type 30 A x 2, 15 A x 1, 10 A x 6
License light unit screw 1.5 N·m (0.2 kgf·m, 1.1 lbf·ft)
Sidestand switch bolt 10 N·m (1.0 kgf·m, 7 lbf·ft)