CYLINDER HEAD/VALVES
9-11
CYLINDER HEAD REMOVAL
Remove the following:
– exhaust system (page 3-15)
– intake manifold (page 6-64)
– thermostat (page 7-9)
– ECT sensor (page 6-74)
– O
2
sensor (page 6-76)
– cylinder head cover (page 9-6)
– cam sprocket (page 9-7)
– camshaft/rocker arm (if the cylinder head is dis-
assembled) (page 9-7)
– spark plug (page 4-7)
Drain the coolant (page 7-7).
Drain the engine oil (page 4-11).
Remove the main wire harness wire band, CKP sen-
sor wire band, ignition coil wire band and spark
plug wire band from the clamp stay.
Remove the two bolts and clamp stay.
Disconnect the water hose.
Remove the two 6 mm bolts.
Remove the four 9 mm bolts and washers in 2 or 3
steps in a crisscross pattern.
Remove the cylinder head.
Remove the gasket and two dowel pins.
Remove the cam chain guide.
STAY
BANDS
BOLTS
HOSE
Do not strike the
cylinder head too
hard and do not
damage the mating
surface with a
screwdriver.
BOLTS
CYLINDER HEAD
BOLTS/WASHERS
CHAIN GUIDE
DOWEL PINS
GASKET
Summary of Contents for SH300I 2006
