Honda SH300I 2006, Manual

Page: 384 / 511

HYDRAULIC BRAKE
17-26
INSTALLATION
Install the delay valve and tighten the delay valve
mounting bolts.
Connect the brake hoses to the delay valve with the
oil bolts and new sealing washers.
Tighten the brake hose oil bolts to the specified
torque while setting the hose joints against the
stoppers on the delay valve.
Apply clean brake fluid to the brake pipe joint nut
thread.
Install the brake pipe to the delay valve and tighten
the joint nut to the specified torque.
Fill brake fluid and bleed air the hydraulic system
(page 17-7).
Install the front upper cover (page 3-9).
DELAY VALVE (ABS TYPE)
REMOVAL
Remove the following:
– front upper cover (page 3-9)
– front handlebar cover (page 3-14)
– rear handlebar cover (page 3-14)
– front inner cover (page 3-10)
Drain the brake fluid from the hydraulic system
(page 17-7).
Loosen the joint nut and disconnect the brake pipe
from the delay valve.
Remove the oil bolt, sealing washers and discon-
nect the brake hose.
Remove the delay valve mounting bolts and delay
valve.
TORQUE: 34 N·m (3.5 kgf·m, 25 lbf·ft)
TORQUE: 14 N·m (1.4 kgf·m, 10 lbf·ft)
BRAKE PIPE
JOINT NUT
BOLTS DELAY VALVE
OIL BOLTS/
SEALING WASHERS
Be careful not to
damage the brake
pipe.
When removing the
brake pipe joint
nuts, cover the end
of the pipes to pre-
vent contamination.
OIL BOLT
BRAKE PIPE JOINT NUT
SEALING WASHERS
DELAY VALVE
BOLTS