Honda SH300I 2006, Manual

Page: 339 / 511

FRONT WHEEL/SUSPENSION/STEERING
15-25
Install the right handlebar weight and tighten the
new screw.
Set the front master cylinder by aligning the end of
the master cylinder with the punch mark on the han-
dlebar.
Set the holder with the "UP" mark facing up and
tighten the upper bolt first, then tighten the lower
bolt to the specified torque.
Connect the front brake light switch connectors.
Clean the inside surface of the left handlebar grip
and the outside surface of the handlebar.
Apply Honda Bond A or equivalent to the inside sur-
face of the handlebar grip and to the outside surface
of the handlebar.
Wait 3 – 5 minutes and install the grip. Rotate the
grip for even application of the adhesive.
HANDLEBAR WEIGHT
SCREW
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
FRONT MASTER CYLINDER
BOLTS
"UP" MARK
PUNCH MARK
HOLDER
FRONT BRAKE LIGHT
SWITCH CONNECTORS
Allow the adhesive
to dry for 1 hour
before using.
HANDLEBAR GRIP
HANDLEBAR