ENGINE REMOVAL/INSTALLATION
8-8
Remove the engine hanger bracket nut, bolt and
separate the engine hanger bracket B from the
engine hanger bracket A.
INSPECTION
Remove the dust seals and inner collar from the
engine hanger bracket B.
Check the needle bearings in engine hanger bracket
B for wear or damage.
Also check that the bearing outer race fits tightly in
hanger bracket B.
Check the bushings in the engine hanger bracket A
and swing rod for wear, deterioration or damage.
BEARING REPLACEMENT
Remove the engine hanger bracket B (page 8-4).
Remove the engine hanger needle bearings from
the engine hanger bracket B using the special tool.
NUT/BOLT
BRACKET B
BRACKET A
INNER COLLAR
DUST SEAL
BEARINGS
DUST SEAL
SWING ROD
BRACKET A
TOOL:
Bearing remover, 20 mm
07931-MA70000
BEARING REMOVER
BEARING
Summary of Contents for SH300I 2006
