Honda SH300I 2006, Manual

Page: 337 / 511

FRONT WHEEL/SUSPENSION/STEERING
15-23
Remove the handlebar bolts.
Remove the handlebar.
Remove the lower throttle housing and throttle
pipe/right handlebar grip from the handlebar.
Disconnect the throttle cables from the throttle pipe.
INSTALLATION
When removing the right handlebar grip from the
throttle pipe, apply Honda Bond A or equivalent to
the inside of the grip and to the clean surfaces of the
throttle pipe.
Wait 3 – 5 minutes and install the grip.
Rotate the grip for even application of the adhesive.
Clean the sliding surfaces of the throttle pipe and
handlebar.
Apply 0.1 – 0.2 g of grease to the throttle pipe flange
groove and sliding surface.
Connect the throttle cable to the throttle pipe flange.
Install the lower throttle housing and throttle grip/
throttle pipe onto the handlebar and set the lower
throttle housing by aligning the locating pin with
the hole in the handlebar.
HANDLEBAR
BOLTS
THROTTLE
PIPE/GRIP
LOWER HOUSING
THROTTLE CABLES
Allow the adhesive
to dry for 1 hour
before using.
HANDLEBAR GRIP
THROTTLE PIPE
CABLES
Align
LOWER HOUSING
THROTTLE
PIPE/GRIP