Honda SH300I 2006, Manual

Page: 165 / 511

FUEL SYSTEM (PGM-FI)
6-55
ASSEMBLY
Install the new O-ring to the throttle body.
• Install the O-ring to the throttle body properly. If
the O-ring is not installed properly, the idle air
will leak and engine idle speed will be unstable.
Install the sensor unit to the throttle body by align-
ing the clip of the TP sensor and boss of the throttle
valve.
• The light pressure is sufficient to assemble the
sensor unit and throttle body in their correct
position. If you cannot assemble them easily, the
clip may be misaligned. Do not attempt to force
them together and make sure that the clip is
aligned.
• Perform the TP sensor reset procedure (page 6-
58) after installing the sensor unit.
Install and tighten the torx screws to the specified
torque.
TORX SCREWS
O-RING
THROTTLE BODY
IACV
THROTTLE CABLE
BRACKET
SCREW
2.1 N·m (0.2 kgf·m,
1.5 lbf·ft)
3.4 N·m (0.3 kgf·m,
2.5 lbf·ft)
3.4 N·m (0.3 kgf·m,
2.5 lbf·ft)
SENSOR UNIT
TORX SCREWS
SET PLATE
SCREW
3.4 N·m (0.3 kgf·m,
2.5 lbf·ft)
WIRE CLAMP
PLATE
Align
O-RING SENSOR UNIT
THROTTLE BODY
TORQUE: 3.4 N·m (0.3 kgf·m, 2.5 lbf·ft)
TORX SCREWS