Honda NSS250A Reflex 2001-2007, Manual

Page: 245 / 718

FUEL SYSTEM (PGM-FI)
6-91
10.Check if the MIL blinks.
If the MIL begins short blink (0.3 seconds), the
throttle valve fully closed position is reset.
• If the MIL stays lit, the throttle valve fully closed
position is not reset, repeat the reset procedure
from step 3.
11.Turn the ignition switch OFF.
12.Connect the ECT sensor 3P (Gray) connector.
13.Remove the battery (page 19-6).
14.Install the luggage lower box (page 3-16).
15.Disconnect the DLC from the SCS connector.
Install the dummy connector.
16.Install the battery cover (page 19-6).
17.Support the scooter on its center stand.
Start the engine, let it idle and check the engine
revolution.
• If the engine revolution is out of specification,
check the following:
– Throttle operation (page 4-5)
– IACV (page 6-103)
– Intake air leak
MIL ON
IGNITION SWITCH ON
OFF
RESET RECEIVING PATTERN
SUCCESSFUL PATTERN
0.3 sec.
0.1 sec.
1.3 sec.
within 10 sec.
0.3 sec.
3P (Gray) CONNECTOR
STANDARD: 1,500
±
100 min
-1
(rpm)
NSS250A shown:
DUMMY CONNECTOR
SCS CONNECTOR
maxiscooter-club.ru