Honda NSS250A Reflex 2001-2007, Manual

Page: 247 / 718

FUEL SYSTEM (PGM-FI)
6-93
If you check this
test, the ignition
switch OFF, then
turn the ignition
switch ON and
engine stop switch
" ".
Place the bank angle sensor is horizontal (normal
position) as shown, and ignition switch ON and
engine stop switch " ".
The bank angle sensor is normal if the engine stop
relay clicks and power supply is closed.
Incline the bank angle sensor approximately 49
±
4
°
to the left or right with keep the ignition switch ON
and engine stop switch " ".
The bank angle sensor is normal if the engine stop
relay clicks and power supply is open.
INPUT VOLTAGE/GROUND LINE
INSPECTION
• Check the bank angle sensor system inspection
(page 6-92) before checking the input voltage/
ground line.
1. Input Voltage Line Inspection
Turn the ignition switch OFF.
Disconnect the bank angle sensor 3P (Black) con-
nector (page 6-94).
Turn the ignition switch ON and engine stop
switch " ".
Measure the voltage at the bank angle sensor 3P
(Black) connector of wire side and ground.
Is there battery voltage?
YES – GO TO STEP 2.
NO – • Open circuit in Black wire
• Blown fuse (MAIN B or ECU, IGN
fuse)
2. Engine Stop Relay Coil Line Inspection
Measure the voltage at the bank angle sensor 3P
(Black) connector of wire side and ground.
Is there battery voltage?
YES – GO TO STEP 3.
NO – • Open circuit in Black/orange wire
• Faulty engine stop relay
• Faulty engine stop switch
NORMAL POSITION 49
±
4
°
(approximately)
49
±
4
°
(approximately)
49
°
bank angle position
CONNECTION: Black (+) – Ground
BANK ANGLE SENSOR 3P CONNECTOR
(Wire side/female terminals)
Black
CONNECTION: Black/orange (+) – Ground
BANK ANGLE SENSOR 3P CONNECTOR
(Wire side/female terminals)
Black/orange
maxiscooter-club.ru