Honda NSS250A Reflex 2001-2007, Manual

Page: 102 / 718

FRAME/BODY PANELS/EXHAUST SYSTEM
3-24
CONSOLE BOX
REMOVAL/INSTALLATION
Open the console box.
Open the console box fully by pushing it forward
about half of travel and pulling out the console box
slowly.
Push the console box lightly and slide the pin to left,
then pull out the console box from the rail.
Install and close the console box.
• When installing the console box, make sure that
the console box lock release switch of the con-
sole box locked and unlocked.
DISASSEMBLY/ASSEMBLY
LEFT INNER BOX
Remove the screw and spring.
Remove the lock pin cap, E clip, washer, wave
washer, collar and lock pin.
Remove the screws and left inner rail.
Remove the screws and left inner box lid.
Assembly is in the reverse order of disassembly.
Align the pin with
groove.
RAILS
PIN
PIN CONSOLE BOX
CONSOLE BOX INNER BOX LID
SCREWS 4 x 12 E CLIP
WASHER
LOCK PIN CAP
WAVE WASHER
COLLAR
LOCK PIN
LEFT INNER RAIL
SPRING LEFT INNER RAIL
SCREWS 4 x 16
SCREWS 4 x 12
TORQUE:
Left inner rail screw:
1.0 N·m (0.1 kgf·m, 0.7 lbf·ft)
Left inner box lid screw:
1.0 N·m (0.1 kgf·m, 0.7 lbf·ft)
maxiscooter-club.ru