Honda NSS250A Reflex 2001-2007, Manual

Page: 225 / 718

FUEL SYSTEM (PGM-FI)
6-71
FUEL LINE INSPECTION
FUEL PRESSURE RELIEVING
• Before disconnecting the fuel feed hose, relieve
pressure from the system as follows.
1. Remove the luggage lower box (page 3-16).
Temporarily install the battery.
• Be careful not to contact the terminals of the bat-
tery to the frame body.
2. Remove the clamp and disconnect the fuel pump
unit 5P (Natural) connector.
3. Start the engine, and let it idle until it stalls.
4. Turn the ignition switch OFF.
5. Disconnect the battery negative (–) cable (page
19-6).
QUICK CONNECT FITTING REMOVAL
FUEL PUMP UNIT SIDE
1. Relieve the fuel pressure (page 6-71).
2. Check the fuel quick connect fitting for dirt, and
clean if necessary.
Place a shop towel over the quick connect fitting.
3. Pull and release the rubber cap as shown.
4. Hold the connector with one hand and squeeze
the retainer tabs with the other hand release
them from the locking pawls.
Pull the connector off then remove the retainer.
• Absorb the remaining fuel in the fuel feed hose
from flowing out with a shop towel.
• Be careful not to damage the hose or other parts.
• Do not use tools.
• If the connector does not move, keep the retainer
tabs pressed down, and alternately pull and push
the connector until it comes off easily.
FUEL PUMP UNIT 5P CONNECTOR
CLAMP
QUICK CONNECT FITTING
RETAINER TABS CONNECTOR
RUBBER CAP LOCKING PAWLS
maxiscooter-club.ru