Honda NSS250A Reflex 2001-2007, Manual

Page: 580 / 718

LIGHTS/METERS/SWITCHES
22-10
COMBINATION METER
SYSTEM INSPECTION
Remove the screen garnish (page 3-18).
Disconnect the combination meter 28P (Gray) con-
nector.
Perform the following inspection at combination
meter connector of the wire side.
POWER VOLTAGE INPUT LINE
Turn the ignition switch ON then measure the volt-
age between the combination meter connector of
the wire side and ground.
There should be battery voltage.
If there is no voltage, check the following:
– Loose connector
– Blown METER fuse (5 A)
– Faulty ignition switch (page 23-26)
– Open or short circuit in Black/orange wire
BACK UP VOLTAGE INPUT LINE
Measure the voltage between the combination
meter connector of the wire side and ground.
There should be battery voltage at all times.
If there is no voltage, check the following:
– Loose connector
– Blown CLOCK, TRUNK, ANSWER BACK fuse (10
A)
– Open or short circuit in Light green/yellow wire
28P CONNECTOR
CONNECTION: Black/orange (+) – Ground (–)
28P CONNECTOR
(Wire side/female terminal)
Black/orange
CONNECTION: Light green/yellow (+) – Ground (–)
28P CONNECTOR
(Wire side/female terminal)
Light green/yellow
maxiscooter-club.ru