Honda NSS250A Reflex 2001-2007, Manual

Page: 255 / 718

FUEL SYSTEM (PGM-FI)
6-101
2. Ground Line Inspection
Turn the ignition switch OFF.
Check the continuity between the test harness
and ground.
Is there continuity?
YES – Intermittent failure
NO – • Open circuit in Green wire
• Open circuit in Green/black wire
3. Engine Stop Relay Inspection 1
Turn the ignition switch OFF.
Remove the engine stop relay (page 6-79).
Turn the ignition switch ON and engine stop
switch " ".
Measure the voltage at the fuse/relay box termi-
nals of wire side.
Is there battery voltage?
YES – GO TO STEP 4.
NO – • Open circuit in power input line
between the battery and engine stop
relay.
• Blown fuse (MAIN B and/or ECU, IGN
fuse)
• Faulty bank angle sensor
4. Engine Stop Relay Inspection 2
Turn the ignition switch OFF.
Jump the engine stop relay connector terminals.
Turn the ignition switch ON and engine stop
switch " ".
Measure the voltage at the PCM 33P (Black) con-
nector terminal of wire side and ground.
Is there battery voltage?
YES – Inspect the engine stop relay (page 6-
79).
NO – Open circuit in Black/white wire
between the engine stop relay and the
PCM
CONNECTION: 3 – Ground
4 – Ground
22 – Ground
(4) (3)
TEST HARNESS PIN BOX
(22)
CONNECTION: Red/green (+) – Black/orange (–)
Red/green
Black/orange
FUSE/RELAY BOX
(Wire side/female terminals)
CONNECTION: Black – Black/white
CONNECTION: 33 (+) – Ground (–)
Black
Black/white
JUMPER WIRE
FUSE/RELAY BOX
(Wire side/female terminals)
(33)
TEST HARNESS PIN BOX
maxiscooter-club.ru