Honda NSS250A Reflex 2001-2007, Manual

Page: 493 / 718

HYDRAULIC BRAKE
17-27
DELAY VALVE
REMOVAL/INSTALLATION
Spilled fluid can damage painted, plastic, or rubber
parts. Place a rag over these parts whenever the
system is serviced.
When removing the brake hose oil bolt, cover the
end of the hose or pipe to prevent contamination.
Secure the hose to prevent fluid from leaking out.
Remove the screen garnish (page 3-18).
Drain the left (combined) brake line hydraulic sys-
tem (page 17-7).
Remove the joint nut and disconnect the brake pipe.
Remove the oil bolts, sealing washers and discon-
nect the brake hoses.
Remove the delay valve mounting bolts and delay
valve.
Installation is in the reverse order of removal.
• At installation, replace the sealing washers with
new ones.
• Tighten the brake hose oil bolts while set the
hose eyelets against the stopper on the delay
valve.
Fill and bleed the left (combined) brake line hydrau-
lic system (page 17-9).
Install the screen garnish (page 3-18).
Be careful not to
damage the brake
pipe.
OIL BOLTS
SEALING WASHERS
BRAKE PIPE
JOINT NUT
NSS250A shown:
Apply clean brake
fluid to the brake
pipe joint nut
threads.
TORQUE:
Brake pipe joint nut: 14 N·m (1.4 kgf·m, 10 lbf·ft)
Brake hose oil bolt: 34 N·m (3.5 kgf·m, 25 lbf·ft)
DELAY VALVE
BOLTS
NSS250A shown:
maxiscooter-club.ru