Honda NSS250A Reflex 2001-2007, Manual

Page: 614 / 718

Honda Smart Card Key System
23-8
DIAGNOSTIC CODE INDICATION
Remove the battery cover (page 19-6).
Remove the dummy connector.
Connect the inspection adapter to the registration
2P (Red) connector.
Connect the Red clip of the inspection adaptor to
the 12V battery positive (+) terminal and black clip
to the negative (–) terminal.
Turn the ignition switch ON with the properly regis-
tered card key.
The Honda Smart Card Key indicator will come on
for approx. ten seconds then it will start blinking to
indicate the diagnostic code if the system is abnor-
mal.
The blinking frequency is repeated for two minutes.
The ignition switch light (Blue LED) starts to blink
when the system is normal. (The system is in the
normal mode and the diagnostic code does not
appear.)
DIAGNOSTIC CODE
When the system (Handle lock module) enters the diagnostic mode before starting registration mode:
TOOL:
Inspection adaptor
07XMZ-MBW0101
BATTERY
INSPECTION ADAPTOR
2P CONNECTOR
NSS250A shown:
Honda Smart Card Key INDICATOR
BLINKING PATTERN SYMPTOM PROBLEM PROCEDURE
Code key sig-
nals cannot be
sent Faulty LF
antenna or wire
harness Follow the trouble-
shooting (page 23-
11)
Code key sig-
nals cannot be
received Faulty RF unit or
wire harness Follow the trouble-
shooting (page 23-
12)
maxiscooter-club.ru