Honda NSS250A Reflex 2001-2007, Manual

Page: 626 / 718

Honda Smart Card Key System
23-20
Honda Smart Card Key INDICATOR
INPUT VOLTAGE LINE INSPECTION
(WITH TEST HARNESS)
Connect the test harness 21P between the handle
lock module 21P (Black) connector and main wire
harness (page 23-17).
INDICATOR DOES NOT COME ON
Short the test harness 21P and ground with the
jumper wire.
The indicator should illuminate when the ignition
switch is turned ON.
If the indicator does not illuminate, check the follow-
ing:
Measure the voltage between the test harness and
ground.
There should be battery voltage at all times without
approx. two seconds while the indicator is illumi-
nated after the ignition switch is turned ON.
If the battery voltage does not appear, check for
open circuit in Yellow/white wire.
If the battery voltage appears, faulty handle lock
module.
INDICATOR STAYS ON
Check the continuity between the test harness and
ground.
If there is continuity, check for short circuit in Yel-
low/white wire.
There is no continuity, faulty combination meter
panel circuit board.
CONNECTION: 7 (+) – Ground (–)
TEST HARNESS 21P
(7)
CONNECTION: 7 (+) – Ground (–)
TEST HARNESS 21P
(7)
CONNECTION: 7 (+) – Ground (–)
TEST HARNESS 21P
(7)
maxiscooter-club.ru