Honda NSS250A Reflex 2001-2007, Manual

Page: 706 / 718

Honda S Matic System (NSS250A)
24-62
5. Check that the "AM 1" is blinking on the gear
position indicator on the meter.
Rotate the throttle grip from the fully closed posi-
tion to the fully opened position, then back to the
fully closed position.
6. Check that the "AM 2" is blinking on the gear
position indicator on the meter (PCM is measur-
ing the fully opened/closed positions of the throt-
tle valve).
• Do not operate the throttle grip while "AM 2" is
blinking.
Push the starter switch and start the engine.
7. "AM 3", then "AM 4" blinks on the gear position
indicator on the meter (PCM is detecting the
position of the drive pulley face and automati-
cally setting the position of the drive pulley face
on 1st.).
• Be careful because the wheel rotates in varied
speed.
8. Check that the "AM 5" is blinking on the gear
position indicator on the meter (Storing the data
detected by the PCM).
Turn the ignition switch OFF.
The gear position indicator on the meter turns
off.
9. Remove the special tool from the DLC connector.
10.Turn the ignition switch ON and check the gear
position indicator blinking.
• If the gear position indicator blinks, follow the
Self-Diagnostic system (page 24-13).
11.Install the battery cover (page 19-6).
GEAR POSITION INDICATOR
THROTTLE GRIP
STARTER SWITCH
GEAR POSITION INDICATOR
GEAR POSITION INDICATOR
IGNITION SWITCH
GEAR POSITION INDICATOR
maxiscooter-club.ru