Honda NSS250A Reflex 2001-2007, Manual

Page: 145 / 718

LUBRICATION SYSTEM
5-5
OIL PRESSURE INSPECTION
• For EOP switch inspection (page 22-25)
Start the engine and warm it up.
Stop the engine.
Remove the EOP switch cover.
Remove the screw and disconnect the EOP switch
wire.
Remove the EOP switch from the crankcase.
Connect the oil pressure gauge to the oil pressure
gauge attachment.
Check the engine oil level, if the oil level is below or
near the lower level line, add the recommended oil
to the upper level (page 4-10).
Warm the engine to normal operating temperature
(approximately 80
°
C/176
°
F) and increase the engine
speed to 5,000 min
-1
(rpm) and read the oil pressure.
Stop the engine and remove the tools.
Apply sealant to the threads of the EOP switch.
Install the EOP switch and tighten it to the specified
torque.
Connect the EOP switch wire and tighten the screw
securely.
Install EOP switch cover.
Start the engine and check that the oil pressure indi-
cator turns off after a few seconds. If the oil pres-
sure indicator stays on, stop the engine immediately
and determine the cause (page 22-25).
EOP SWITCH SCREW
SWITCH WIRE COVER
TOOLS:
Oil pressure gauge set
07506-3000001
Oil pressure gauge attachment 07406-0030000
STANDARD:
530 kPa (5.4 kgf/cm
2
, 77 psi) at 5,000 min
-1
(rpm)/
(80
°
C/176
°
F)
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
OIL PRESSURE GAUGE
maxiscooter-club.ru