Honda NSS250A Reflex 2001-2007, Manual

Page: 553 / 718

IGNITION SYSTEM
20-11
IGNITION TIMING
Start the engine, warm it up to normal operating
temperature and stop it.
Remove the timing hole cap.
Remove the maintenance lid of the luggage lower
box (page 3-16).
• Read the instructions for timing light operation.
Connect the timing light to the spark plug wire.
Start the engine, let it idle and check the ignition
timing.
The ignition timing is correct if the index notch on
the right crankcase cover aligns between the "F"
mark on the flywheel as shown.
Check that the O-
ring is in good
condition. Replace
it if necessary.
Coat the O-ring with oil and install it to the timing
hole cap.
Apply oil to the timing hole cap threads.
Install the timing hole cap with the O-ring and
tighten it to the specified torque.
Install the removed parts in the reverse order of
removal.
TIMING HOLE CAP
TIMING LIGHT
IDLE SPEED: 1,500
±
100 min
-1
(rpm)
"F" MARK INDEX NOTCH
TORQUE: 6 N·m (0.6 kgf·m, 4.4 lbf·ft)
O-RING
TIMING HOLE CAP
maxiscooter-club.ru