Honda CBR125R, Owner'S Manual

Page: 342 / 430

HYDRAULIC BRAKE
15-10
Install new brake pads to the brake caliper so their
ends seat against the retainer and brake caliper pin
bolt A.
Make sure that the retainer is installed to the brake
caliper.
Apply silicone grease to the brake pad hanger pin
O-ring and install it to the pad pin groove.
Install the brake pad hanger pin by pushing the
pads against the pad spring to align the hanger pin
holes in the pads and brake caliper.
Tighten the brake pad hanger pin to the specified
torque.
Install the rubber plug.
Operate the brake pedal to seat the caliper pistons
against the pads.
BRAKE DISC INSPECTION
Visually inspect the brake discs for damage or crack.
Measure the brake disc thickness using a microme-
ter.
Replace the brake disc if the smallest measurement
is less than the service limit.
BRAKE PADS RETAINER
PIN BOLT A
O-RING
HANGER PIN
TORQUE: 17 N·m (1.7 kgf·m, 13 lbf·ft)
HANGER PIN RUBBER PLUG
SERVICE LIMITS:
FRONT: 3.5 mm (0.14 in)
REAR: 3.5 mm (0.14 in)