Honda CBR125R, Owner'S Manual

Page: 340 / 430

HYDRAULIC BRAKE
15-8
BRAKE PAD/DISC
FRONT BRAKE PAD REPLACEMENT
Always replace the
brake pads in pairs
to assure even disc
pressure.
Push the caliper pistons all the way in to allow
installation of new brake pads.
Check the brake fluid level in the brake master cylin-
der reservoir as this operation causes the level to
rise.
Do not operate the
brake lever after
removing the brake
pads.
Remove the brake pad hanger pin and brake pads.
Check that the O-ring is in good condition, replace if
necessary.
Install new brake pads to the brake caliper so their
ends seat against the retainer and brake caliper pin
bolt A.
Make sure that the retainer is installed to the brake
caliper.
Apply silicone grease to the brake pad hanger pin
O-ring and install it to the hanger pin groove.
Install the brake pad hanger pin by pushing the
pads against the pad spring to align the hanger pin
holes in the pads and brake caliper.
HANGER PIN/O-RING BRAKE PADS
PIN BOLT A
RETAINER BRAKE PADS
O-RING
HANGER PIN