Honda CBR125R, Owner'S Manual

Page: 145 / 430

FUEL SYSTEM (PGM-FI)
5-53
Disconnect the IACV 4P (Black) connector and injec-
tor 2P (Black) connector.
Disconnect the injector side of the quick connect fit-
ting (page 5-59).
Loosen the insulator band screw (throttle body side)
and remove the throttle body assembly.
Loosen the throttle cable lock nut and adjusting nut
then disconnect the throttle cable from the throttle
drum and cable stay.
DISASSEMBLY
• The throttle body/sensor unit is factory pre-set.
Do not disassemble in a way other than shown in
this manual.
• Do not snap the throttle valve from full open to
full close after the throttle cable has been
removed. It may cause incorrect idle operation.
• Do not damage the throttle body. It may cause
incorrect throttle valve operation.
• Do not loosen or tighten the white painted nut
and screw of the throttle body. Loosening or
tightening it can cause throttle valve and idle
control failure.
• Always clean around the throttle body before
each sensor removal to prevent dirt and debris
from entering the air passage.
Remove the injector (page 5-60).
QUICK CONNECT FITTING
4P (BLACK) CONNECTOR 2P (BLACK)
CONNECTOR
THROTTLE BODY ASSEMBLY
BAND SCREW
LOCK NUT ADJUSTING NUT
THROTTLE CABLE THROTTLE DRUM
WHITE PAINTED