Holtek HT-IDE, User Manual

Page: 57 / 258

→
To delete all breakpoints
•
Choose the Breakpoint command from the Debug menu or press the hot
key Ctrl+B
A breakpoint dialog box is displayed (Fig 5-3)
•
Choose the Clear All button to delete all breakpoints from the break-
points list box
•
Press the OK button to confirm
→
To enable (disable) a breakpoint
•
Choose the Breakpoint command from the Debug menu or press the hot
key Ctrl+B
A breakpoint dialog box is displayed (Fig 5-3)
•
Choose the disabled (enabled) breakpoint from the breakpoint list box
•
Press the Enable (Disable) button, to enable or disable this breakpoint
•
Press the OK button to confirm
Trace the Application Program
The HT-IDE provides a powerful trace mechanism which records the
execution processes and all relative information when the HT-IDE is emu-
lating the application program. The trace mechanism provides qualifiers to
filter specified instructions, and trigger conditions in order to stop the trace
recording. It also provides a method to record a specified count of the trace
records before or after a trigger point.
Note
When the HT-IDE starts emulating (refer to the section on Emulation of
the Application Programs), the trace mechanism will begin to record the
executing instructions and relative information automatically, but not vice
versa.
About the trace mechanism and its requirements
The basic requirement for initializing the trace mechanism is to set the
Trace Mode with or without Qualify. The Trace Mode defines the trace scope
of the application program and Qualify defines the filter conditions of the
trace recording.
Chapter 5 HT-IDE Menu – Debug
47