Holtek HT-IDE, User Manual, Page: 188 / 258

The panel configuration items are:
• µ
C controller. Selects the micro controller of the current project.
•
COM and SEG. Select the number of the COMMON and SEGMENT of
the LCD driver respectively. The default number of the LCD driver for
this micro controller is displayed. Ensure that these numbers are the
same as the actual setting number of the LCD driver for the micro
controller.
•
Width and Height. Enter the size of panel screen in pixels. They can be
changed in order to adjust the panel screen.
•
Directory of panel file. Select the directory where the panel file is stored.
Use the the browse button to change the directory or set the same
directory as the project’s.
•
Dot Matrix Mode. To simulate the dot matrix type of LCD panel or not.
The dot matrix screen is similar to Fig 14-5.
Fig 14-5
Note Do not set different COM or SEG number from the actual corresponding
numbers which are set for the microcontroller LCD, otherwise the results
will be unpredictable.
Select the patterns and their positions
•
When Fig 14-2 appears during the panel file creation procedure, i.e. after
completing the panel configuration, patterns must be selected by using
the Pattern Information dialog box and selecting the COM/SEG positions
for these patterns.
•
If Fig 14-2 has appeared from the Open command of the File menu, then
new patterns may be added, original patterns changed to new patterns or
patterns deleted from the COM/SEG table. In addition, the COM/SEG
positions of the patterns can be changed.
HT-IDE User’s Guide
178