92
F6-13 inching frequency
0.00 Hz ~ maximum frequency [ 2.00 Hz ]
F6-14 inching acceleration time
0.0s
～
6500.0s
【
20.0s
】
F6-15 inching deceleration time
0.0s
～
6500.0s
【
20.0s
】
The given frequency and acceleration / deceleration time of the frequency inverter during define inching.
During inching operation, the starting mode is fixed as direct starting mode and the stopping mode is fixed as
deceleration stopping mode.
F6 -16 terminal inching takes precedence
0
～
1
【
0
】
This parameter is used to set whether the terminal jog function has the highest priority.
When the terminal inching takes precedence, if the terminal inching command appears during operation, the
frequency inverter will switch to the terminal point running status
F6 - 17 acceleration time 2
0.0s ~ 6500.0 S [ model determination ]
F6 - 18 deceleration time 2
0.0s ~ 6500.0 S [ model determination ]
F6 - 19 acceleration time 3
0.0s ~ 6500.0 S [ model determination ]
F6 - 20 deceleration time 3
0.0s ~ 6500.0 S [ model determination ]
F6 - 21 acceleration time 4
0.0s ~ 6500.0 S [ model determination ]
F6 - 22 deceleration time 4
0.0s ~ 6500.0 S [ model determination ]
HV610 has 4 groups of acceleration and deceleration times, which are F0 - 10 \ F0 - 11 and the above 3 groups
of acceleration and deceleration times respectively.
The definitions of the four groups of acceleration and deceleration times are exactly the same, please refer to F0
- 10 and F0 - 11 related instructions.
Through different combinations of multifunctional digital input terminals x, four groups of acceleration and
deceleration times can be switched and selected, and the specific user can please refer to the relevant instructions in
function codes F5 - 01 ~ F5 - 05 for the method.
F6 -23 acceleration and deceleration mode
0
～
1
【
0
】
Select the frequency change mode of the frequency inverter during start-up and stop - up.
0: the output frequency of linear acceleration and deceleration
Increases or decreases linearly according to a constant slope.
