57
Abbreviation symbol
Meaning of the contents
Prohibit forward-turning side drive state
Indicates that the inhibit forward drive input (P-OT) signal is in an open
circuit state.
It is forbidden to reverse the side drive state.
Indicates that the inhibit reverse side drive input (N-OT) signal is in an open
circuit state.
The forward and reverse side drive states are prohibited
Indicates that the forward-rotation-prohibited side drive input (P-OT) signal
and the reverse-rotation-prohibited side drive input (N-OT) signal are in an
open circuit state.
Force Stop Status
Indicates that the servo drive is in a forced stop state after receiving a
forced stop input (FSTP) signal.
No motor test function in progress
Indicates a state in which no motor test function is being performed.
Alarm status
Blinking display Alarm number
8.2 Operation of Parameters (PA
) in Panel Operator
Displays the number beginning with PA on the panel operator.
The following describes how to set the parameters used in this manual.
8.2.1 Setting Method of "Numerical Setting Type"
The following describes the setting method of numerical setting type, taking the setting value of speed loop
gain (Pn100) from 40.0 to 100.0 as an example.
Steps
Display after operation
Operation
key
Operation
1
Press the F key to select the parameter mode.
In case of dual-axis drive, long press F key more than 3
seconds, and Axis A and Axis B will be switched alternately.
2
Press UP or DOWN to display "Pn100".
3
Press S key to display the current set value of Pn100.
4
Press the left key to move the flashing digits to make 4
flashing. (You can change the number of digits displayed by
blinking.)
5
Press the UP key 6 times to change the set value to "100.0".
6
After pressing the F key, the value display will flash. In this
way, the set value changes from 40.0 to 100.0.
7
Press S key to return to the display of "Pn100".
◆
When the setting range is above 6 bits
Since the panel operator can only display 5 digits, the settings above 6 digits are shown as follows.
The flashing display on the left
indicates the position of the digit
(front bit ● middle bit ● rear bit).
The digit display plus the digit
indicates the parameter value
First 2 digits
First 2 digits
Middle 4 digits
"-"is displayed only if it is
with symbol and negative
When the number
is negative, the
decimal is lit up
Press
Press
Press
Last 4 digits
