Hitachi IJ RX2, Service Manual

Page: 40 / 252

2-23
3 The measurement is completed in four minutes, and coefficient (calculated value)
will be displayed.
If “Fault” is displayed for processing state, follow the instructions given in
“4.9 Viscometer maintenance.”
4 Press OK.
If the OK key is pressed when the process status is
“normal end”, the coefficient
will be registered, and the circulation control screen will be displayed.
2.6.2 Operation test of viscometer
●This function allows you to check the viscometer operation and measure the current ink
viscosity. Note that this operation test is not to determine the coefficient.
● It is not necessary to use new ink for operation test.
OK
Cancel
<the previous calibration>
Exec.time 2015/07/07 11:30
< the current calibration >
Exec.time 2009/07/07 12:45
Proc. Status: Ended
Viscometer calibration
HOME
[Stop ] 2015.07.07 12:45
Com=0
Plunger falling time Plunger falling time
1st
2nd
5th
Average
3rd
4th
Ink temperature XX ( )
Standard X. XXX (mPa
▪
s)
X.XX (sec)
X.XX (sec)
X.XX (sec)
X.XX (sec)
X.XX (sec)
X.XX (sec)
1st
2nd
5th
Average
3rd
4th
Ink temperature XX ( )
Standard X. XXX (mPa
▪
s)
X.XX (sec)
X.XX (sec)
X.XX (sec)
X.XX (sec)
X.XX (sec)
X.XX (sec)
Coefficient XXXX
Coefficient XXXX
Ink viscosity XXX
When updating coefficient, press [OK].
Coefficient
OK
[Note]
The coefficient value will not be registered when Cancel is pressed instead of OK key.
[Standard value of the viscometer calibration] 1000 to 2000
* The value stated above is a reference. There will be no problem even If the coefficient
value displayed is other than stated above as long as data of Plunger falling time fall
within a similar range.