HYBRID/TROUBLE SHOOTING
3–43
INSPECTION PROCEDURE: P0500 (TC51)
1.
Set the starter key to the "LOCK" position.
2.
Connect the diagnosis tool (HINO-DX) to the vehicle.
3.
Set the starter key to the "ON" position.
4.
Select [Brake] on the diagnosis tool screen.
5.
In [Fault Information], check if any DTC related to the vehicle
speed sensor system is detected.
NO
YES
1.
Set the starter key to the "LOCK" position.
2.
Disconnect the connectors of ABS ECU and combination meter
(40P).
3.
Using the electrical tester, measure the resistance between the
ABS ECU vehicle-side connector and the terminal of combination
meter (40P) vehicle-side connector.
NO
YES
1
Inspecting the ABS ECU [HINO-DX]
SHTS03ZZZ0300032
Is any DTC detected from the ABS?
Perform troubleshooting for each DTC of
ABS ECU.
Go to step 2.
2
Inspecting the continuity of vehicle wire harness (between ABS ECU and the combination
meter)
SHTS03ZZZ0300033
Measurement
conditions
Tester
connections
Standard values
Starter key: LOCK
ABS ECU vehicle-
side connector
–
Combination
meter (40P) vehi-
cle-side connector
22nd terminal
–
22nd terminal
Less than 1
Is the measured value within the range of standard value?
Go to step 3.
Repair or replace the vehicle wire harness
(between the ABS ECU and the combination
meter).
