Geophysical Survey Systems, Inc.
SIR® 4000
Manual
MN72-433 Rev F
83
5.2: StructureScan3D
This mode is for collecting very high-resolution 3D data over a concrete slab or wall with a 2.6 GHz,
2 GHz Palm, 1.6 GHz, 1.5 GHz or 1.0 GHz antenna. This will produce a 3D cube of data that can be
viewed in planview at differing depths so as to note clear locations for coring and cutting. You can also
use the 3D data to quickly create graphics for reports that are more meaningful to your customers than
2D profiles.
StructureScan3D Setup
1
Select StructureScan3D from the modes at the top of the Introduction screen.
2
If using a Smart Antenna, such as the 52600S, the correct antenna will be selected. However, if using
an older antenna you’ll need to select the correct frequency from the Antenna soft key at the bottom
of the screen.
3
After verifying or selecting your
antenna, select whether this is a
New Project or if you’re continuing
a project with the Last Used
Settings. You will then see the
setup screen and, if an antenna is
connected and the dead-man switch
is engaged, it will initialize and
data will start to scroll across.
4
For instructions on how to
configure the Radar and Systems
menu refer to the StructureScan2D
section in this chapter.
Summary of Contents for SIR 4000
