GSK GSK980TDc, Manual

Page: 57 / 470

Chapter 2 MSTF Command
39
Ⅰ
Progra
mming
G10 L3; Set to be the tool life management data
input mod
P01; Tool group number, too group number
setting range(1
～
32)
N_: tool life count mode, N0 is the
used time(minute) to count tool
life and N1 is the used number
of times to count the tool
life(unit: min)
T0101 L500 N0; Tool number, life, mode(number of
times) setting
T0201 L600 N1; Tool number, life and mode(min) setting
P02; Another tool group number
T0303 L200 N0; L_: tool life data, the specified value
can be time or number of times
according to the different count
N value
T0304 L300 N0;
G11; Cancel the tool life management data
input mode
M30;
Note 1: The tool group numbers specified by P may not be the continuous, but it is better to gradually
increase the sequence number to easily search the tool group number.
Note 2: The tool life is 0 when the life data L_ is omitted, and the tool mode is 0 (minute) when the specified
mode N_ is omitted, at the time, the system only counts and doest not alarm for the output.
Note 3: Other commands between G10 L3 and G11 are ignored.
Note 4: Running the tool life preset program (such as O0020) completely clear all previous life data and
preset the life data according to the program requirements.
Note 5: Prevent the life data from being modified manually when the part programs are running until the run
state stops (except for running the tool life preset programs).
Note 6: All tool life data is stored when power-down.
2) Input tool life management data in the tool life management window
Input directly the tool life management data in tool compensation- >tool life window in MDI
mode, parameter switch ON and 3-level operation limit.
A. alter data:
In tool compensation -> tool life window, press to move the tool to the life position,
input directly data, such as 500, press to confirm the input. Press to
complete data input (tool offset, life) .