GSK GSK980TDc, Manual

Page: 278 / 470

GSK980TDc Turning CNC System User Manual
258
Ⅱ
Operation
2) If the mode (G, M, T, F code) of the current block where the cursor locates is defaulted and
inconsistent with the running mode of this block, the corresponding modal function should be
executed to continue next step.
3) Press key to enter the Auto mode, then press key to start the execution.
8.1.5 Adjustment of the feedrate, rapid rate
In Auto mode, the running speed can be changed by adjusting the feedrate override, rapid
override. It doesn’t need to change the settings of the program and parameter.
z Adjustment of the feedrate override
Press , , 16-level real time feedrate can be obtained.
Note 1: The actual feedrate value is specified by F in feedrate override adjustment;
Note 2: Actual feedrate= value specified by F× feedrate override
z Adjustment of rapid override
It can realize the F0, 25 ％ , 50 ％ , 100 ％ 4-level real time rapid override adjustment by
pressing , , , .
Note 1: The rapid traverse speeds of X, Z axis are set by the system parameter No.022, No.023
X axis actual rapid traverse rate = value set by parameter No.022X×rapid override
Z axis actual rapid traverse rate = value set by parameter No.022Z×rapid override
Note 2: When the rapid override is F0, the min. rapid traverse rate is set by bit parameter No.032.
8.1.6 Spindle speed adjustment
While the spindle speed is controlled by the analog voltage output in Auto mode, it can be
adjusted by spindle override.
Press , to adjust the spindle override for the spindle speed, it can realize 8-level
real-time override adjustment between 50 ％～ 120 ％ .