GSK GSK980TDc, Manual

Page: 363 / 470

Chapter 2 Definition and Connection of Interface Signal
341
Ⅲ
C
o
n
n
e
c
tio
n
S1 ～ S4 output are inactive at power on. If any code of them is executed, the corresponding S
signal output is active and held on, and the other S signal outputs are cancelled. S1
～
S4 outputs are
cancelled when executing S00 code, and only one of them is active at a time.
2.8.6 Spindle automatic gearing control
z Relevant signal (defined by standard PLC program)
M41
～
M44: spindle automatic gear shifting output signals. It supports 4-gear spindle automatic
gear shifting control when the system selects the spindle analog value control(0 ～
10V analog voltage output)
M41I,M42I: spindle automatic gear shifting No.1, 2 gear in-position signals to support gear
shifting in-position check function
z Signal diagnosis
Signal
M42I M41I M44 M43 M42 M41
Diagnosis address X1.6 X1.5 Y1.3 Y1.2 Y1.1 Y1.0
Interface pin CN61.15 CN61.14 CN62.12 CN62.11 CN62.10 CN62.09
z Signal connection
The circuit for M41~M44 is shown in Fig.2-47:
Fig. 2-47
z Control parameter
Bit parameter
0 0 1 ACS
Bit4 =1: Spindle analog volume control, set to 1 if using spindle automatic gearing
=0: Spindle switching volume control
K 1 5 SHT AGIM AGIN AGER
AGER =1: Spindle automatic gearing active
=0: Spindle automatic gearing inactive
AGIN =1: Detect M41I, M42I signal when shifting to gear 1, 2
=0: Not detect M41I, M42I signal when shifting to gear 1, 2
AGIM =1: Active when M41I, M42I signals disconnecting to +24V
=0: Active when M41I, M42I signals connecting to +24V
SHT =1: spindle gear power-down executes the memory
=0: spindle gear power-down does not execute the memory
Data parameter
0 3 7 GRMAX1
0 3 8 GRMAX2
0 3 9 GRMAX3
0 4 0 GRMAX4