GSK GSK980TDc, Manual

Page: 395 / 470

Chapter 3 Parameters
373
V
olume
Ⅲ
Connecti
o
n
“Stop”.
mailto:M@SP=1
Bit4 1: Not detect software stroke limit
0: Detect software stroke limit
Bit3 1: Emergency stop inactive
0: Emergency stop active
Bit1 1: Software limit is inactive after power-on and before machine zero return;
0: Software limit is active after power-on and before machine zero return;
1 7 4 *** *** *** *** KEY1 *** *** ***
Bit3 1: Program switch ON at power on
0: Program switch OFF at power on
1 7 5 SPFD SAR THDA VAL5 VAL4 VALY VALZ VALX
Bit7 1: In cutting feed, do not permit the spindle stopping rotation; the spindle stops, the feed also
stops when the system appears No.404 alarm cutting
0: In cutting feed, permit the spindle stops rotation; the spindle stops rotation, but the feed
does not stop
Bit6 1: Detect spindle SAR signal prior to cutting
0: Not detect spindle SAR signal prior to cutting
Bit5 1: Thread machining is the exponential acceleration/deceleration
0: Thread machining is the linear acceleration/deceleration
Bit4 1: 5
th
movement key is _positive, is _negative
0: 5
th
movement key is _positive, is _negative
Bit3 1: 4
th
movement key is positive, is negative
0: 4
th
movement key is positive
，
is negative
Bit2 1: Y movement key is positive
，
is negative
0: Y movement key is positive
，
is negative
Bit1 1: movement key is positive
，
is negative
0: Z movement key is positive
，
is negative
Bit0 1: X movement key is positive ， is negative
0: X movement key is positive
，
is negative
1 8 0 NAT *** *** *** *** *** *** SPOS
Bit7 1: Function ATAN, ASIN range is 90.0
～
270.0;
0: Function ATAN, ASIN range is -90.0
～
90.0
Bit0 1: DIS TO GO displayed in POS&PRG page
0: RELATIVE POS displayed in POS&PRG page
1 8 1 RLC MRC ZCL *** MCL *** *** LCNMD
Bit7 1: G52 local coordinate system is cancelled after reset;
0: G52 local coordinate system is not cancelled after reset;
Bit6 1: G52 local coordinate system is cancelled after the execution of M30, M02;