GSK GSK980TDc, Manual

Page: 260 / 470

GSK980TDc Turning CNC System User Manual
240
Ⅱ
Operation
3) Pressing can enter the subordinate menu, which can be omitted. The display is
shown below:
4) Press
，
to move the cursor to the program name which is to be selected.
5) Refer to the above Step 3) to enter the subordinate menu, at the moment, press directly
to open it. The step can be omitted to execute the Step 6).
6) Press or , and the selected program is opened and the CNC skips to “PRG.
CONTENT” page.
Note: when the CNC is connected with the U disk, the above similar method is referred to open the program in
the U disk.
6.4 Executing a Program
After the program to be executed is selected by the method in OPERATION, Section 6.3, select the
Auto mode, then press key (or external cycle start key), the program will be executed