GSK GSK980TDc, Manual

Page: 460 / 470

GSK980TDc Turning CNC System User Manual
438
Ⅲ
Connection
Address Alarm No. Content
A0005.4
1044 Spindle is clamped not to rotate or feed
A0007.0
2000 Hydraulic motor is not started
A0007.1
2001 Safety door has been opened
A0007.3
2003 Alarm for the tool pot unclocked
5.2.7 K address （ K parameter, standard PLC definition ）
RRW =1: the cursor returning to the head of the program in any working modes when the
system resets is valid;
=0: the cursor returning to the head of the program in edit mode when the system resets is
valid
RSJG =1: the spindle lubricating, cooling output keep when the system resets;
=0: the spindle lubricating, cooling output close when the system resets.
OUTR =1: pressing can start the program run in MDI mode;
=0: pressing cannot start the program run in MDI mode.
OVRI =1: feedrate override is fixed to 100%
；
=0: feedrate override can be adjusted.
JSPD =1: the spindle JOG in any modes are valid;
=0: the spindle JOG in MANUAL, MPG, ZERO RETURN are valid.
LMIS =1: overtravel signal LOW/HIGH alarm of each axis
；
=0: overtravel signal LOW/HIGH alarm of each axis.
LMIT =1: overtravel of each axis is valid;
=0: overtravel of each axis is invalid.
K 1 1 CHOT *** CHET TCPS CTCP TSGN CHTB CHTA
CHTA: tool change mode selection bit 0
CHTB: tool change mode selection bit 1
（
see table below
）
TSGN =0: tool signal HIGH (be connected to +24V) is valid
=1: tool signal HIGH (be not connected to +24V) is valid
CTCP =0: do not check the tool post lock signal
=1: check the tool post lock signal
TCPS =0: tool post lock signal LOW(be not connected to +24V) is valid
=1: tool post lock signal LOW(be connected to +24V) is valid
CHET=0: do check the tool signal when the tool change ends
=1: check the tool signal when the tool change ends
CHTB CHTA Tool post type
0 0 Standard tool change mode B
0 1 Standard tool change mode A
1 0 Yantai AK31 series(6, 8,10, 12 tools)
1 1 Liuxin hydraulic tool post （ 8, 10, 12 tools ）