GSK 980TC3 Series, Manual

Page: 115 / 226

Chapter 6 Feedrate Control
103
Ⅲ
Operation
Chapter 6
Feedrate Control
6.1 Rapid Traverse Rate
General
The 4 gears ( F0
，
25
％，
50
％
, 100%) can be used for rapid traverse rate.
Feedrate: Actual moving speed is obtained by multiplying the override value by the value
set by the data parameter P088~092 either in the auto mode or
manual operation mode (including manual reference point return
and program zero return).
F0 ： it is set by the data parameter P093.
Signal rapid traverse override coded signal
（
G14#0~G14#2
）
［ Classification ］ Input signal
［
Function
］
It is the rapid traverse override signal
［ Operation ］ The coded signal is corresponded to the following override
Rapid traverse override coded signal
Override value
RV4 RV2 RV1 ROV1=0 ROV2=1
0 0 0 0% 0%
0 0 1 25% 20%
0 1 0 50% 40%
0 1 1 100% 60%
1 0 0 —— 80%
1 0 1 —— 100%
6.2 Feedrate Override
General A programmed feedrate can be reduced or increased by a percentage selected by the
override dial. This feature is used to check a program. For example, when a feedrate of
100 mm/minute is specified during the program, setting the override to 50% to move the
tool at 50 mm/min.
Signal Feedrate override coded check signal （ G012#0~G012#4 ）
［
Classification
］
Input signal
［
Function
］
Cutting feedrate override signal divided into 5 binary coded signals which
are corresponded to the override:
The override can be selected with 10% increment within 0~200%.
［ Operation ］ Actual feedrate is obtained by multiplying the specified speed by the
override value selected by this signal.
［ Operation ］ The coded signal is corresponded to the following override
Cutting feedrate override coded signal
FV16 FV8 FV4 FV2 FV1
Override value
0 0 0 0 0 0%