GRAUPNER mx-16 HOTT, Programming Manual

Page: 33 / 180

33 Using the receiver for the fi rst time
connect its power supply; release the button again.
If the reset is carried out with the transmitter switched
off, or if the receiver is not already bound, the receiver
LED fl ashes red slowly after about two or three sec-
onds; at this stage it is immediately possible to initiate a
binding process at the transmitter. If the reset is carried
out with an already bound receiver, if the transmitter is
switched on, and if the associated model memory is ac-
tive, then the LED lights up green after a short interval to
indicate that your transmitter / receiving system is ready
for use once more.
Please note the following:
Resetting the receiver resets ALL the settings
stored in the receiver to the default settings, with
the exception of the binding information! If you
carry out a reset by mistake, this means that you
will have to restore all the receiver settings entered
using the Telemetry menu.
On the other hand, a deliberate RESET is particu-
larly useful if you wish to “re-house” a receiver in a
different model, as it represents an easy method of
avoiding the transference of unsuitable settings.