Gerber SOLARA UV2, Owner'S Manual

Page: 139 / 163

CHAPTER 7 139
Troubleshooting
Objects are printing in the wrong place
Problem Solution Notes
Are you using the supplied line
conditioner? Install the supplied line
conditioner to ensure an
even power supply. See “Power supply” on
page 16.
Are you using the correct
communications cable? Use the correct
communications cable. See “Networking your
GERBER SOLARA UV2
printer” on page 25.
Is the image printing on top of the
UV shields? Perform a manual
material scan. See “
Manually initiating a
material width scan” on
page 69.
Ink not curing
Problem Solution Notes
Are the UV bulbs beyond their
recommended life?
the UV lamp cartridges. cartridge” on page
Replace one or both of See “Replacing the UV
lamp
124.
Are the lamps set the correct height Adjust the lamp height. the material”
on page 42. for the material loaded?
See “Loading
The ink forms small puddles on t the prin
Problem Solution Notes
Is there air in the lines?
e air from ink
Perform a purge to
remov
lines. See “
Purging an ink line to
remove air” on page 141.
Are print head nozzles misfiring?
d
performance. Prime and
swab the print heads.
page 101. and
”Priming the print heads”
on page 97.
Print a NozzleJob test
print to check print hea See “Printing the NozzleJob
test print” on
Job data errors
Data errors and interruptions during printing
Problem Solution Notes
Are all communications cables reconnect See “Checking network
connected properly?
Check and
communication cables as
necessary.
connections” on page 32.
Is the computer you are sending the
job from performing other tasks? Close out of all other
unnecessary tasks. See “Pausing a job due to
data starvation” on page 83.