Gerber SOLARA UV2, Owner'S Manual

Page: 31 / 163

CHAPTER 3 31
Setting up the GERBER SOLARA UV2
5
Click Properties to open the Internet Protocol (TCP/IP) Properties dialog box.
6
Click Use the following IP address:
7
Enter 169.254.0.1 for IP Address.
8
Press Tab to automatically enter the correct Subnet Mask (255.255.0.0).
9
Do not enter a Default Gateway if using direct connection, or unless instructed by your
network administrator.
10
Click OK to save the settings and exit the Properties dialog box.
Assigning a network name for the printer
You can assign a name for your GERBER SOLARA UV2 printer to help you distinguish it from
other GERBER SOLARA UV2s on your network. This is helpful when DHCP is activated as the
printer's IP address may change.
Note: The default name of each printer is SOLARA UV2-##, where “##” refers to the last two
digits of the printers unique MAC address. The Default option in the SET NETWORK NAME
menu will restore this network name.
To assign a network name
1
From the MAIN MENU press F3, Setup to open the SETUP MENU.
SETUP MENU
F1 Network Calibrate
Diag Vacuum
ENTER for Main Menu
2
Press F1, Network to open the NETWORK INFO menu.
NETWORK INFO
IP Address Configure F3
MAC Address
ENTER for Main Menu