Gerber SOLARA UV2, Owner'S Manual

Page: 22 / 163

CHAPTER 2 22
Product Overview
Power switch
When the power switch is turned on the GERBER SOLARA UV2 will automatically initiate
the following procedures during startup:
♦
Firmware startup and internal diagnostics
♦
Check if material is loaded
♦
Check ink levels and fill as needed
♦
UV Lamp cool-down
♦
Print head warming
Firmware startup and internal diagnostics
When the GERBER SOLARA UV2 is turned on the internal firmware starts up just like a
computer. The LCD display on the left side of the printer will display the name of the printer
and the firmware version that is currently installed. The printer will then proceed with a series
of internal diagnostics to test the operation of various components including sensors, fans, ink
system, lamps and network connections. The display will list off each of the internal diagnostics
as it is being preformed. If there are any internal issues, a message will be displayed after
startup is complete. See “Messages” on page 146.
Automatic material check
If there is no material loaded when the printer is turned on, you will be prompted to load
material. After loading the material, lowering the pinch wheels and adjusting the beam height, a
material width scan is performed. If the printer is powered up with previously loaded material
in place, the printer will automatically enter the Material Setup menu and prompt you to adjust
the beam height for the material loaded. See “Loading the Material” on page 42.
Automatic ink level check
After checking for material the printer will check the ink levels in each of the six ink reservoirs.
If any of the reservoirs are low, the printer will automatically fill them upon startup, or when
Start Job is selected. If an ink cartridge is empty a message will be displayed after startup is
complete. See “Loading the Inks” on page 39.
UV lamp cool-down
When you first turn on the printer, the UV bulbs begin a three minute cool down sequence to
ensure that the bulbs are ready to strike. After striking, the UV bulbs require a 60 second warm-
up cycle prior to use. When they have reached their operating temperature, the cooling fans
automatically turn on to maintain the proper temperature.