Gerber SOLARA UV2, Owner'S Manual

Page: 48 / 163

CHAPTER 4 48
Loading Inks and Materials
Move the UV shield by
grabbing the shield
bracket here
To adjust the right UV shield
The right UV shield can move up and down the entire length of the carriage beam over the
platen to adjust to any material width. The shield shares the carriage beam with the pinch
wheels, so it may be necessary to move the pinch wheels in order to get the shield to the
desired location. Pinch wheels should always be placed over a corresponding grit wheel
when loading material. If working with material that has a width smaller then 36" (92cm) it
may be necessary to remove the right shield and move it around other pinch wheels.
(See following procedure)
CAUTION: To prevent damage and misalignment of the UV shields, only move the
UV shields by touching the brackets as shown in the following picture.
To move the right UV shield assembly
1
Turn the Material Wheel clockwise to raise the beam height to provide ample room to
remove the UV shield assembly from the beam.
2
Loosen the center screw (5mm) on the top section of the bracket until it widens enough
to slip out of the notches in the carriage beam and remove.
Move the UV shield by
grabbing the shield
bracket here
DO NOT TOUCH
DO NOT TOUCH
DO NOT TOUCH
DO NOT TOUCH