Gerber SOLARA UV2, Owner'S Manual

Page: 81 / 163

CHAPTER 5 81
Printing Jobs on the GERBER SOLARA UV2
Printing multiple jobs
Multi mode lets you run several jobs without having to press Start-Job between each one. When
one job finishes, the next job begins immediately on the same material loaded in the printer.
When all jobs that have been sent are completed, the printer waits for another job and begins
printing as soon as it is received.
Multi mode is designed for printing multiple jobs that use
the same material.
Tip: Printing jobs in multi mode is the most efficient use of lamp life since the next job starts
before the one minute lamp time-out occurs.
To print multiple jobs
1
Press F2, Mode to toggle between Single and Multi mode. Choose Multi.
MAIN MENU
Setup
F2 Mode: Multi Operate
Job Status: No Job
2
Load the material in the printer. See “Loading the material” on page 42.
Tip: If the printer is in a remote location and not near the computer, you can press F1
(Start-Job) on the printer before you send the jobs from the computer. The first job will
start immediately after it is received.
3
Send the jobs from your computer to the printer. When the first job is received at the
printer, Job Status changes to
Ready ,
and
Start-Job
blinks.
MAIN MENU
F1 Start-Job Setup
Mode: Multi Operate
Job Status: Ready
4
Verify that the correct material for all the jobs you wish to print is loaded in the
GERBER SOLARA UV2 and press F1, Start-Job.
5
Before the job starts to print a reminder window will appear reminding you to check
the settings for the lamp height and the pinch wheel force depending on the type of
material you loaded.
REMINDER: Set/Check REMINDER: Set/Check
Lamp Height: LOW POS Lamp Height: HIGH POS
Wheels: HIGH FORCE Wheels: LOW FORCE
(Press a Key) (Press a Key)
Default setup for vinyl material Default setup for rigid material
Check to make sure these setting are correct and press any key to start printing the job.
If you need to make adjustments use the following guidelines.