Gerber SOLARA UV2, Owner'S Manual

Page: 147 / 163

CHAPTER 7 147
Troubleshooting
Common Warning Messages Description
OUT OF MATERIAL
Material End Found.
Job CANCELED
(Press a key)
Rear material sensor indicates end of material. Current job is
canceled. Load new material to fix.
No Material has
been loaded
(Press a key)
Pinch wheels have been lowered but either the front or rear
material sensor does not detect material.
MATERIAL OUT!
Operation requires
material
Displayed if attempting to perform a material width scan when
either the front or rear material sensor indicates no material.
Job + Margin
won't fit material!
Job > mat'l width
92.7 > 91.4 mm
Job including the allowance for left and right print margins will
not fit on the material. To view job width without print margins,
navigate to the WIDTH entry in the Job Info menu.
PINCHWHEELS ARE UP
Pinch Wheels must be
down to operate.
(Press key to retry)
The requested operation cannot be performed while the pinch-
wheels are raised. Lower the pinch-wheels and try again.
Pinch Wheels must be
RAISED to operate!
(Press any key)
Displayed if the MotionJob test job is attempted while the pinch
wheels are lowered.
WARNING:
INK CARTRIDGE EMPTY
F2=Details
Press a key
Indicates that an ink cartridge is empty. F2 will bring up the Ink
Level menu so that the operator can see which cartridge to
replace.
Waiting for Lamps
to cool down
Please wait…
The operation about to be performed requires that the lamps are
cool. This message will appear while the lamps are in cool-down
mode. The operation will automatically continue when the lamps
have completed the cooling cycle.
Waiting for Ink
to fill.
Please wait…
Purge and ink dry load cycles require full ink reservoirs. This
message appears while the ink reservoirs are being filled. The
next step is displayed when the filling has completed.
INK Refilling
has started!
This message displays briefly after the user presses the Start
Refill key in the Ink menu. The appropriate ink solenoids will be
opened immediately following this message.
No Ink is Ready
to be Refilled!
This message displays briefly after the user presses the Start
Refill key in the Ink menu and no ink is in a condition that will
allow refilling. The most likely cause is all ink reservoirs are full.
WARNING: Empty Ink
cartridges: x
ENTER = Start Refill
CANCEL= abort
One or more ink cartridges became empty in the middle of an ink
dry load operation. The inks are identified in the 2nd line.
Replace the empty ink cartridges and press ENTER to continue
the operation.