Gerber SOLARA UV2, Owner'S Manual

Page: 137 / 163

CHAPTER 7 137
Troubleshooting
Material jams
Problem Solution Notes
Did you use Gerber-approved
material? Replace with new,
Gerber-approved material See “Compatible material”
on page 43.
Is the material folded, bent or curled? Replace with new Gerber-
approved material. Store
material in correct
environmental conditions.
See “Compatible material”
on page 43.
Did you load the material correctly
(straight) into the left side of the
printer? Reload the material. See “Loading the material”
on page 42.
Are the pinch wheels set to the
correct force setting for the material
loaded? Adjust the pinch wheel
force setting for the
material loaded. See “Loading the material”
on page 42.
Is the beam height adjusted
correctly? Adjust the beam height
within the acceptable
range for the material. See “Loading the material”
on page 42.
Is the GERBER SOLARA UV2 being
used in adverse environmental
conditions? Use the SOLARA UV2 in
the specified
environment. See ”Ambient conditions”
on page 15.
Is there foreign material in the grit
wheels? Clean the grit wheels with
the supplied brush. See “Cleaning the grit
wheels” on page 104.
Quality of printed output
The print is blurred
Problem Solution Notes
Is the material damp? Replace with dry, Gerber-
approved material. Store
material in correct
environmental conditions. See “Compatible material”
on page 43.
Is the material folded, bent or curled? Replace with new Gerber-
approved material. Store
material in correct
environmental conditions.
See “Compatible material”
on page 43.
Is the printable side of the material
loaded correctly? Reload the material with
the printable side of the
material facing up. See “Loading the material”
on page 42.