Gerber SOLARA UV2, Owner'S Manual

Page: 61 / 163

CHAPTER 4 61
Loading Inks and Materials
3
Identify which table is the front table and which is the rear. The rear table will have a
metal material guide on the right side.
Rigid material
Material guide
4
Roll the tables into position in front of and in back of the printer using the auxiliary set
of wheels at the bottom of the folded tables.
5
Fold out the table legs and lock into place. The legs should be pointed toward the
printer.
6
Move the tables into position and angle the table brackets into the slits on either end of
the platen, hooking them over the metal knobs.
7
Lower the two material table latches over the metal knobs on the printer and tighten
the set screw (5mm) for each.
8
Verify that both tables are level with the printer platen before loading material. Adjust
the casters at the bottom of each table leg as necessary.