Gerber SOLARA UV2, Owner'S Manual

Page: 55 / 163

CHAPTER 4 55
Loading Inks and Materials
11
Holding the material in position, push in the material load lever to engage the pinch
wheels.
From the front, push the
material load lever in to
lower the pinch wheels.
12
When you load material into the printer, if the beam height needs to be adjusted the
following message will be displayed:
MATERIAL SETUP:
Adjust Beam Height
Or Press CANCEL for
Main Menu
13
Adjust the beam height by turning the Material Wheel.
♦
Turn the Material Wheel clockwise to raise the beam height.
♦
Turn the Material Wheel counterclockwise to lower the beam height.
DOWN UP
14
Turn the Material Wheel to slowly lower the pinch wheels. When the pinch wheels are
at the correct height above the material the audible signal will stop and the material
hold-down fans will turn on.
15
Continue to lower the pinch wheels until the single starts again. As soon as it starts,
turn the Material Wheel clockwise very slowly until the signal stops again. From this
point, turn the wheel one complete revolution clockwise. The height is now correct.
Turn Counterclockwise Turn Clockwise