Gerber SOLARA UV2, Owner'S Manual

Page: 136 / 163

CHAPTER 7 136
Troubleshooting
Printer issues
Printer will not turn on
Problem Solution Notes
Is the power cord securely attached
to the printer and the plugged into an
active outlet? Plug in the power cord. See “Ambient conditions”
on page 15.
Is the GERBER SOLARA UV2 power
switch turned on? Turn on the power
switch. See “Starting the printer”
on page 21.
Job will not print
Problem Solution Notes
Is the front cover open? Close the front cover.
Is the shutter door open? Close the shutter door.
Is the Pinch Wheel lever engaged? Push in the Pinch Wheel
lever. See “Loading the material”
on page 42.
Is the beam height adjusted
correctly? Adjust the beam height
within the acceptable
range for the material. See “Loading the material”
on page 42.
Is the material covering the
appropriate material sensors? Load the material on the
left side of the printer. See “Loading the material”
on page 42.
Are all of the ink reservoirs filled
with ink? Check the Ink Levels and
refill the ink reservoirs if
necessary. See “Checking ink levels”
on page 41.
Has the printer been activated? Enter the code provided
by Gerber or licensed
distributor. See “Activating your
GERBER SOLARA UV2
printer” on page 34.
Winder does not roll up the material
Problem Solution Notes
Is the Winder power cord plugged
in? Plug in the Winder. See “Using the winding
unit” on page 56.
Is the Winder power switch turned
on? Toggle the power switch
correctly to the on setting
rather than resting
between on and off. See “Using the winding
unit” on page 56.